A.light year
B.micron
C.angstrom
D.milestone
E.millimeter
Explanation: The correct answer is milestone.
Submitted by: Academy of Pakistan
Civil Engineering MCQs: 3,057 practice questions with answer choices and available explanations. Page 193 of 204.
Civil Engineering MCQs by topic
Surveying100Structural Analysis53Fluid Mechanics98Highway Engineering129Environmental Engineering146
Now you can submit the latest Civil Engineering MCQs MCQs from your test! SUBMIT HERE
Civil Engineering MCQs
Showing page 193 of 204 · 3,057 total solved questions available.
⚡Start Quiz Mode to Practice Like the Real Exam!
A.TOD>COD>BOD
B.COD>BOD>TOD
C.BOD>COD>TOD
D.TOD>BOD>COD
Explanation: The correct answer is TOD>COD>BOD.
Submitted by: Academy of Pakistan
A.B/4
B.B/3
C.B/2
D.B/6
Explanation: The correct answer is B/6.
Submitted by: Academy of Pakistan
A.newton meter
B.kilogram meter/sec
C.joule
D.pascal per sec
E.watt
Explanation: The correct answer is watt.
Submitted by: Academy of Pakistan
A.filtration
B.sedimentation
C.sludge digestion
D.sludge disposal
Explanation: The correct answer is sludge disposal.
Submitted by: Academy of Pakistan
A.1.0 m
B.2.0 m
C.4.0 m
D.3.0 m
Explanation: The correct answer is 3.0 m.
Submitted by: Academy of Pakistan
A.3 hours
B.4 hours
C.2 hours
D.5 hours
Explanation: The correct answer is 4 hours.
Submitted by: Academy of Pakistan
A.Brick ballast has poor drainage characteristics.
B.Gravel ballast gives better performance on soft formation.
C.Coal ash is not used as ballast with steel or cast iron sleepers.
D.Sand ballast causes excessive wear on top of rail
Explanation: The correct answer is Sand ballast causes excessive wear on top of rail.
Submitted by: Academy of Pakistan
A.hip rafter
B.valley rafter
C.eaves board
D.ridge board
Explanation: The correct answer is ridge board.
Submitted by: Academy of Pakistan
A.both (1) and (2)
B.both (1) and (3)
C.all (1), (2) and (3)
D.only (1)
Explanation: The correct answer is all (1), (2) and (3).
Submitted by: Academy of Pakistan
A.The diameter of the pipes is the nominal diameter of internal bore
B.All pipes are measured along the centre line of the pipes in metres
C.All pipes and fittings are classified according to their diameters
D.All the above
Explanation: The correct answer is All the above.
Submitted by: Academy of Pakistan
A.both 2.5mm and 5.0 mm penetrations
B.2.5 mm penetration only
C.5.0 mm penetration only
D.7.5 mm penetration only
Explanation: The correct answer is both 2.5mm and 5.0 mm penetrations.
Submitted by: Academy of Pakistan
A.mechanism condition
B.plastic moment condition
C.yield condition
D.equilibrium condition
Explanation: The correct answer is equilibrium condition.
Submitted by: Academy of Pakistan
A.convex
B.concave
C.plano-convex
D.plano-concave
Explanation: The correct answer is concave.
Submitted by: Academy of Pakistan
A.to support the common rafter
B.to prevent the purlins from tilting
C.all of the above
D.to support purlins
Explanation: The correct answer is to prevent the purlins from tilting.
Submitted by: Academy of Pakistan