For design purposes, the normal rate of infiltration... - Solved MCQs & Answer

1372Civil EngineeringMedium

For design purposes, the normal rate of infiltration of ground water into the sewer, is________?

A500 litres/km/cm

B1500 litres/km/cm

C1000 litres/km/cm

D2000 litres/km/cm

Correct answer

D. 2000 litres/km/cm

Explanation

The correct answer is 2000 litres/km/cm.

Related Civil Engineering MCQs

View all 3057 MCQs →

MCQ #1374

The value of energy quantum for radiation of any frequency is proportional to________?

Ans: The frequencyRead →

MCQ #1370

When a uniformly distributed load, shorter than the span of the girder, moves from left to right, then the conditions for maximum bending moment at a section is that________?

Ans: the load position should be such that the section divides the load in the same ratio as it divides theRead →

MCQ #1375

An ideal fluid is________?

Ans: frictionless and incompressibleRead →

MCQ #1369

According to IS : 456- 1978, minimum slenderness ratio for a short column is________?

Ans: less than 12Read →

MCQ #2136

Turbidity is measured on________?

Ans: standard silica scaleRead →

MCQ #2900

In case of bankruptcy of a partnership________?

Ans: The partnership assets (excluding the partners personal assets) only will be used to pay the liabilitiesRead →